New sonoff zigbee

[Mariano_Colmenarejo]

I had some problems with devices are far of the hub, some times fails the transmit and recive process and need repeat process.
Is importan wait some seconds to complete configure process.
An easy method to check the process is ok:
In IDE when change dth versión, the checkInterval change from 720s to 16270s. If process is correct the checkInterval return to 720s in some seconds.
As explain in this link

Multisensors Samsung Battery drop quickly after hub v3 firmware update

Until smarttings offer, if is possible, a solution to return to an acceptable battery life in our sensors and if someone need to improve the duration of the battery (currently about 2, 3 months for CR2450 batteries) of the samsung smatthings sensors or that use the DTH “SmartSense …” with multi-open/close, moisture, temperature or motion devices and do not need as much precision in temperature information. I have added two settings in preferences: Adjust between 1 and 240 minutes of the maximum interval for sending temperature information. Now by default it is 5 minutes if there is a change of => 0.1º and there is no change => 1º. [Screenshot_20210108-183958] Adjust between 0.5º and 3º of the temperature variation that triggers the temperature report even if the maximum interval set i…