I have followed the instructions from this web site
nest install
have enabled OAuth
I have added the DH for nest
Nest appears at a thing but its 0 degrees
Any suggestions
In IDE you need to change the Device Type from Thing (nothing) to Nest.
Don’t know what is the right one for you.
Here a list of possibilities.
Grtn Ben
Thanks but Device type is allready Nest Thermostat
Correction I changed the device type to just Therm then back to Nest Therm and In about a min or two it started working not the same thing with Nest camera
Get an Error
There was a problem retrieving the livestream url.