Multi sensor-- change display to just temperature?

[ero4444 (Eric)]

search. Tho I admit Discourse search is pretty… “bad”, to put it mildly. Low signal to noise.

View temp not motion

Not sure if anyone is still looking to change the default display on the mobile app, but I was able to by using the simulator in the IDE. I have three temp/humidity sensors that showed the temp by default. I chose a code template that required a humidity sensor, picked the sensor I wanted to change, then clicked on the config gear in the top right. I could then change which data tile to display, which also changed the default display in the mobile app. Hope that helps!

There are at least three techniques in that thread.