Hi @mwav3 - tried this without success… Kept a tab open on Chrome in Live Logging on the IDE, then assigned the Z-Wave Tweaker DTH to the Dining Room switch, nothing happened on the log - and I mean zero…
When I switch it back to its original, the log is filled with numerous entries, but not when I assign to it the Z-Wave Tweaker DTH. I did this several times to be sure, and can confirm that assigning the Z-Wave Tweaker DTH produced zero entries in the log.
And now I have a further concern at the back of my mind… I am going around the house removing devices from my old (non-Smartthings) controller and adding them to the Smartthings one, but it all seems a little bit shaky. Many of my devices are a bit old - installation was towards mid-2017, and I have had to find and use Groovy DTHs on here for quite a few devices… So when Smartthings eventually does pull the plug on the Groovy cloud, will I lose all these devices? That’s quite an expense for me, and not one I’d be willing to go into for sure. But I digress, even though it’s connected in a way - as I am trying to solve the problem with these MCOs only to have them stop working a few months down the line.
Anyhow, back to the Z-Wave Tweaker - any ideas on this?
Also, reading back in the original post of the DTH, I see there were others who faced same issue, and they only solved it by associations.