Linear GD00Z-4 Z-Wave - Stays as "Unknown"

Devices & Integrations
13

I take it back…mine is working now. I followed the “Paring” instructions on this page: http://darwinsden.com/linear-z-wave-garage-door-opener-review-gd00z/

Just as that person stated, no idea if pairing it with the sensor installed vertically was key or not…doesn’t matter, it works now.

1.) Reset the controller to factory

  • press the pairing button 5 times
    2.) Pair the Tilt Sensor if in doubt
  • install tilt sensor
  • hold controller button for 7’ish seconds until it beeps
  • open garage door and unit should beep/flash as door opens
    3.) Close garage door
    4.) Pair Controller with ST hub
    5.) Open garage
    6.) Close garage
    7.) Status in dashboard should show up

I have no idea why it worked this time, but not the 11 times before…but it worked finally.

4 Likes