i too experienced this were the z-wave repeater part of the iris plugs would not show up on the app. There are two separate DH for the z-wave repeater part that have some bells and whistles. with one of these DH it will show up in the app. the way you tell if you have a v2 of the iris plug is there are 2 bar code labels on the back, one slightly bigger then the other. HTH
I am releasing the DeviceType code that I wrote to manage the often flakey Z-Wave repeaters found in the Iris V2 Smart Plugs manufactured by CentraLite.
This DTH has a few features that can be very useful in troubleshooting the reliability and stability of these devices. Currently it seems that delayBetween() is currently broken (again) and sends all commands at once, regardless of the specified duration. These devices are notorious for being overwhelmed and will frequently fail to respond to Z-Wave commands if they receive too many in a short period of time. As a workaround, this DTH implements a series of scheduled events to ensure that the device has sufficient time to process commands that it receives.
This DTH can be used for all currently connected Iris Repeaters. It also conta…
and
One of the things that always bothered me with the Iris plug in module is the generic Z-Wave device or switch DTHs when all I wanted was a repeater. This shows a simple interface of online/offline and works with Health Check.
Features
Checks connectivity every 15 minutes
Only shows messages in Recently tab on status change or manual refresh (NOTE: a manual refresh will temporarily remove the health check flag if offline)
Reports after two failed attempts
No events after offline detected to force App Health Check to show correctly (will take about 35 extra minutes)
Current Version: 2.00a
NOTE: If you upgrade to 2.00 or above from an older version, you must press ‘Force Reconfigure’ in the app. If you do not do this step, the DTH will not work correctly.
The code can be pulled from my…