I am rewriting the post 50 by @hgozilla
ST v3 Firmware 25.27 Classic App
The following steps work for me:
1. Exclude it following this steps:
11. Classic App , click 3 lines, then Hub, then Z-wave utilities, then General Device Exclusion, then Remove
12. Power ON Fibaro, wait for the green light and then press 3 quick times on the button
13. Wait for Fibaro to give you a RED light
14. Your App will say your device was excluded
15. Turn OFF power
2. Then include it again:
21. Power ON Fibaro, press quickly 3 times on the button
22. Wait for the green light to stop (it means it was add it to the Hub)
23. Log into the IDE and check your Hub events
24. Look for the event that will look like (zw device: 03, command: …)
25. Write down the number (03) in this case, this is the ID
26. Create a new device manually in the IDE, using the ID and select your Fibaro DH
3. Look in the App, you should have the new device installed