(EDGE Driver-Mc): Fibaro Smart Implant Mc

[TapioX]

@paulthbrit

Try these instructions:

First make Z-Wave Exclusion

1. Click Remove
2. Quickly, triple click button on the device housing or switch connected to IN1 or IN2.
3. LED will start blinking yellow, wait for the removing process to end.

Then Readd Smart Implant to SmartThings

1. In SmartThings App select add device and then scan for nearby devices
2. Quickly, triple click button on the device housing or switch connected to IN1 or IN2.
3. If you are adding in Security S2 Authenticated, scan the DSK QR code or input the underlined part of the DSK (on the device label).
4. LED will start blinking yellow, wait for the adding process to end.

Then select correct profile from Smart Implant’s settings (in detail view)

(EDGE Driver-Mc): Z-Wave Edge Drivers and others with FIBARO devices:

Thanks for this. They were helpful instructions. I didn’t realize that in order to remove a device you had to put it in pairing mode by hitting the button three times. I did this in the app after clicking ‘remove’ and the device, and its child devices, was deleted. Then I went to the add instructions and I saw the following: [IMG_3436] I went to setup and scanned the QR code and got the Success! Message I then went into the device settings and changed the profile to ‘4 External Temperature Probe’ under the first line in ‘settings’'. I also changed the sliders to ‘on’ on the ‘Create Virtual thermostat’ 1-4 and updated fields 67 & 68 to 5 & 60 second updates. That changed the device detail panel to one with spaces for four temperature probes: [IMG_3438] However these temperatur…