I am using 1.17 on WXKG02LM which was previously working on 1.13. It stopped working without me making any changes and I haven’t had time to look into it until now. I removed the switched and successfully paired it again. Unfortunately the switch shows up in standby mode and does not report battery level, both buttons are labeled “standby” and when I press on either of them nothing happens, I don’t see anything on the history tab under this device.
How do I extract the logs that are needed to troubleshoot?
UPD: I found a link to this post so I got CLI smartthings.exe for windows and I fetched the logs specific to the driver. As a result, now that the device is paired there is nothing happening in the logs when I press buttons on the switch. it just says this every few seconds
2023-07-04T20:44:56.451520548+00:00 DEBUG Xiaomi/Aqara Switch and Button v1.17 driver device thread event handled