Hi jkp.
I have obtained the access code from smartthings support, but i also purchased a v3 Aeotec hub, which is also not connecting to either of the 3 Dome sirens.
I suspect i have dome something wrongs, im just not quiet sure what.
To begin with, i added Domes Edge driver following the link provided in this page - [ST EDGE] [RELEASE] Dome Siren (Official 2.0)
Verified the driver was added
Hub → three dots → driver → Dome siren ( And channel hub is registered with is Dome drivers ).
To add the device, as you stated above:
( Siren ) press button 3 times rapidly
( Smartthings app ) Add device → scan for nearby devices
After some time, the process times out, and no devices are found.
I have also tried to exclude them ( No devices are available )
I have reset the siren ( Multiple times ) by holding button for 10 seconds.
Confirmed batteries are 100% ( put them into my motion sensor )
I have 3 of these devices ( sirens ), none of which are visible to my hub.
i have also created a support ticket with Dome for further assistance.
Really appreciate you suggestions, im just not sure what is wrong.