[Depricated] Lock Code Manager

[ethayer (Erik Thayer)]

You probably need to be using the correct DTH for your lock.

garyd9’s DTH would probably work best. You may have to do some research.

I don’t have that lock, so I can’t attest personally. I don’t know why the design decision on the locks firmware would allow the lock key to be reprogrammed via ZWave. That seems… bad.

(Enhanced) Z-Wave Schlage Touchscreen Lock

UPDATED August 22nd, 2015 (see below) As promised elsewhere, here’s my device type for the Schlage touchscreen door lock/deadbolt. This enables querying and setting the door alarm (off/alert/tamper/kick), door alarm sensitivity, and auto-lock modes. (There’s also support for lock/leave and vacation mode, but I don’t have them on the config panel yet.) One thing about this lock is that it’s a SLOW device in z-wave terms. The turnaround time for sending a command and getting a response can be several seconds. So, if you are using this, you’ll notice that trying to change, for example, the alarm mode, will result in the tile going blank with the word “loading…” in it… and then it populating a few seconds later. When changing the alarm MODE, the alarm sensitivity must be re-queried (a…

This app does not delete codes automatically, however if you program for instance slot4 for a code and then enter a user on slot4 on the app, the app will overwrite the manually entered code.

The new beta app has an option to overwrite all codes not entered on the app’s settings. I think this is the most user friendly setting for most people.