Best On-Wall Multi Button Controller for ST?

[mattjfrank (Matt)]

@bdahlem

VRCS4

For a 4 Button you have this one with community created device type.

[OBSOLETE] Leviton VRCS4

I’ve created a device type for the Leviton Vizia VRCS4 Scene Controller. Because of the way the scene commands work, I essentially turned it into a 4 button remote, 3 if there is a built in relay. Setting it up is a bit of work: Note: buttons are numbered 1-4 and dim, with dim at the bottom. To associate, press and hold buttons 1 and 3 on the VRCS4 for 5 seconds, the LEDs will start to flash amber. Hold the SmartThings Hub near to the device tell the SmartThings app to connect a new device. Note: you tell the device to connect before the hub. The hub should find a ZWave Remote. This will eventually be your scene controller. If you have a load connected to the VRCS4 (hardwired): Go back to the SmartThings app dashboard. Press and hold buttons 2 and 4 on the VRCS4 for 5 seconds. The le…

If you want more buttons here is a 7 button, also community created device type.

[OBSOLETE] ZWN-SC7 Enerwave 7 Button Scene Controller

See post #4 for custom Device Type and SmartApp for this device. While I’m still working out a few bugs with my Enerwave Dual Load ZWN-RSM2 I’m hoping someone can get me started with getting the ZWN-SC7 to control devices on/off state. Specifically, I’m hoping to control 3 of the ZWN-RSM2 modules with this device and will be adding even more in the future. In short my rooms almost all have ceiling fans/light combo’s but only one hot wire. So I’m putting the ZWN-RSM2 in the fan canopy and using the ST App and ZWN-SC7 to control them. ST doesn’t support secondary controllers from what I understand, but from the little digging I’ve done. My guess would be that with a custom device type and maybe app, I should be able to accomplish that. ST does recognize and install the device, so I guess…