Anyone uses a Zooz Z-Wave Dimmer Switch ZEN27 for a 4-way or 5 -way?

[HalD (Hal)]

Support site has that covered only for ZEN26 and ZEN27.

http://www.support.getzooz.com/kb/article/211-4-way-diagrams-for-zen26-and-zen27-switches/

The diagram for ZEN22 only for line and load in same box.

http://www.support.getzooz.com/kb/article/73-4-way-diagram-for-zen21-zen22-zen23-and-zen24-switches/

The page for ZEN22 says:

Zooz can only be wired in a 4-way if you have load and line in the same box . If you have load and line separated between two boxes, there’s no way to wire Zooz Ver 2.0 / 3.0 with the two other existing switches.

[TheSmartestHouse]

@HalD

The page for ZEN22 says:

Zooz can only be wired in a 4-way if you have load and line in the same box . If you have load and line separated between two boxes, there’s no way to wire Zooz Ver 2.0 / 3.0 with the two other existing switches.

This actually only refers to a ZEN22 and an on/off switch set-up. The ZAC99 momentary switch option was recently added and in this case, any type of 3-way, 4-way, or 5-way set-up can be accommodated as long as there is neutral in the primary box. We’ll be updating the knowledge base with these details shortly.

@Jaredsrn

My current 4 way set up has 3 boxes. Each have neutrals. Each has traveler running between them. Line is in a box on 1 end and the load is on the box at the other end.

Since this thread was created for the ZEN27 dimmer, we don’t want to post any diagrams relating to the ZEN22 model here but we’ll be happy to send you the instructions once you contact us with your order number!