Aeotec Smart Home Hub/2018/2015 Model Hub Firmware Release Notes - 0.51.02


From time to time I perform a reboot or shutdown of the hub to free up space in the Hub’s memory, since I carry out many tests with drivers in development and that causes unwanted waste to remain in memory. Normally, after a reboot or turning off the hub, the memory status of my Hub V3 drops from Soft Limit to status OK.

I just turned the Hub off and on and the memory result has been very bad :man_facepalming:, it has gone up to Hard Limit and I can see in CLI logs all the drivers are rebooted sequentially time to time to free up hub memory.

I have done a reboot of the Hub from, advanced users and now it has worked fine again, the memory status is down to OK and all the drivers work correctly now.

There is something in firmware 51.02 that is not working fine and it does not always fail for everyone.