Hello, I have an Enphase Envoy device measuring the electrical consumption/production of my house. Since it doesn’t integrate with Smartthings I bought an Aeotec Energy Meter Gen5. Both have one clamp and the clamp is on the same wire… The clamps are side by side but as far as I know there shouldn…

Nevermind… I found out that once I tucked the lid of the electrical cabinet the clamp opened, probably it didn’t click when I connected it… Played with it and the heater and it increased by 1kwh as expected… Now back to figure it out the updates like the guys on the other post… As far as my main qu…

I am struggeling getting any readings from this device. Everthings seems to be installed correctly. I can see the device within ST and I do not get any offline notifications. I renewed my z-wave network within smartthings and did boot the responsible hub several times now. I tried both Aeotec HomeE…

[image] stillerson: This device is hooked to the cable of a stove. Won’t work - there’s insulation and shielding in the way. You’re also trying to measure all three phases at once, which causes them to cancel each other out. Because then I am stupid as a stone. I had the same idea for a m…

But I AM a bit stupid, cause I wrongly translated “stove”. Its not my stove which I try to measure with this device, it is my OVEN. and they are both not connected! so the oven has a “normal” one phase powercable going into a standard 230v wallsocket. But I can not use any compatible “socket measur…

[image] stillerson: one phase powercable going into a standard 230v wallsocket Doesn’t make a difference, because it’s still L, N and E in one cable. This is an option: [image] Heavy Duty Switch - Aeotec Heavy Duty Smart Switch, for indoor and outdoor, with a waterproof design an…

Ja. Thought about this one. And I saw it on sale for 39 euro yesterday. But you also have to cut wires for this, right? Or find an electrician (good luck). And this is going to get too expensive for just “checking the numbers”…

The Eve Energy should work: [Screenshot_20251016_162314_Samsung Internet] 2500 W is plenty for your use case - your device draws 8 A.

And will it show stats within the ST Energy Dashboard as well?

I should have checked before buying, but my (newer) oven works with 16A. Therefore the newer Matter certified Eve Energy (with max 2500W) do not work in my case. Can anyone confirm, that the new Tapo110M Plug works with the Samsung Energy App?

Aeotec Energy Meter

Devices & Integrations

Andreas_Roedl October 16, 2025, 2:35pm 11

Yes! It’s one of the only plugs that are directly supported in SmartThings Energy. I have eight of them and they’re working great - even more fancy features with this driver.

Topic		Replies	Views
Aeotec Clamp Energy Meter in Smartthings Energy Devices & Integrations	45	1787	November 20, 2025
Aeotec Home Energy Meter (Gen 5) overreading Devices & Integrations	2	625	January 12, 2019
Aeotec Home Energy Meter Gen 5 - only Manual Refresh of Meter Readings work Devices & Integrations	12	2501	January 24, 2025
Aeotec Energy Meter Gen 5 not updating Connected Things uncategorized	2	1120	May 17, 2023
Aeotec Home Energy Monitor Gen 2 - Edge Install Devices & Integrations aftergroovy	8	789	June 17, 2025

Aeotec Energy Meter

Related topics