In a custom device, I’m not understanding how I would craft an event to send to myself to get the device to wake up and report its current state (including say battery level) I’d be doing this in a method called from a tile. Not sure it’s even possible, but if it is I’d like to figure out how to d…

Are there any standard Z-Wave Devices with this or similar refresh behavior? I seem to recall seeing this in some Device Type, but forget which one. There’s lots to page through…

I was looking too, didn’t find it. Basically working off the zwave door/window sensor - normally when installed they do the configured() thing def configure() { delayBetween([ zwave.manufacturerSpecificV2.manufacturerSpecificGet().format(), batteryGetCommand() ], 6000) } I want to do somethi…

Jabbera did a wake up for battery on the aeon recessed [image] Aeon recessed door sensor gen 5 device type Connected Things The new recessed door sensor is z wave plus and not compatible with the existing z wave door/window sensor. This device type should work. edit: …

Zwave - how to create event that wakes up device/requests battery?

SmartApps & Automations

greg (Greg) June 15, 2015, 5:16pm 4

Jabbera did a wake up for battery on the aeon recessed

Topic		Replies	Views
Zooz Sensor ZSE18 Control App SmartApps & Automations	12	737	November 1, 2021
Z-wave configuration General Discussion developers	4	1317	June 6, 2016
Using Zwave Configure in an Edge Driver Writing Edge Drivers	18	941	March 24, 2023
Battery level change event SmartApps & Automations	6	1651	November 10, 2015
Z-Wave Thermostat Battery Status? Connected Things	89	15856	May 3, 2016

Zwave - how to create event that wakes up device/requests battery?

Related topics