Zooz Chime Device is Incorrect Type

[h0ckeysk8er (Bruce Pinsky)]

@spiffy577

Hello,

I have an old zooz se33 chime added in Smartthings but smartthings sees it as a simple on / off switch instead of a dimmer switch like it did before. I have to use the dimmer percentages to hear the different chime sounds, ie. 10% is a beep, 20% is two beeps, etc.

But now that it’s listed as a simple on off switch, I cannot change the “light level.” I’ve tried adding a new driver but none are available. I have also tried to contact zooz but unfortunately it’s an obsolete product.

Is there any way, either with a virtual dimmer or something, that I can get the functionality back? I use the chime for a lot of my system.

Thanks,
Josh

There is an official Zooz Edge driver channel. I would check there.

The previous community created DTH was discontinued with the end of Groovy.

[OBSOLETE] Zooz Smart Chime

Open the device in the IDE and change the “Type” field to “Zooz Smart Chime”. If you installed and published the handler then you should see it at the bottom of the list.