Is anyone else having issues with ST multi-sensors battery reading stuck at 100% since the last Hub updates when they change the battery reporting and/or the firmware update for the multi-sensors? Background: I had a multi-sensor stop reporting open/close but stating it was 100%. I check my other…

In the DTH, there is a split when it comes to battery reporting for the Multi Sensors (IF SmartThings then X else Y). ST manuractured ones have one way of calculating and the CentraLites have another. I haven’t looked at the leak or motion detectors to see if they different methods of calculating…

Whats weird is the fact that I have “SmartThings” listed devices that only show 100% while the CentraLite ones show correct then for other devices it’s the opposite. Either way the devs need to look at this and fix it in the DTH’s especially since their changes seemed to break things.

I looked at the moister sensor DTH. For the SmartSense Moisture Sensor DTH, the ST section is calculated the same as the ST in the multi. The Max Volt on it is 2.8 volts (100%) For the CentraLite section they did not add in any of the curValVolts calculations/formulas. That is why it is working f…

Any update to this issue? I’m having the same problem

No change as far as word/fix from support other than working on it emails. The five I have on a modified DTH are going fine. I have two @ 60% and One @ 80%. The other ones had recent battery changes, one 21 days and the other 5 days ago. They are both @ 100%. Temperature and all other sensor fu…

Thats BS. I would reply and tell them thats not a answer and ask when it will be fixed. They made a change that broke it, they can figure out how to fix it.

Here is the modified DTH I am using on my CentraLite 3321-S sensors. Battery reporting seems to be working correctly. I added remarks to explain the changes made. It will not run locally, but it fixed the battery reporting for my 6 sensors. All other senor abilities are also working except for t…

You should put in a Pull Request against the DTh in the smartthings repo. Maybe they can just use your changes or at the very least use it as a base for modifying theirs. Still not sure why they would change something in firmware and not change the DTH to match. This seems like a wide spread issu…

I will give it a try. I guess it is time to learn a little more on the Github side of things!

ST Multi-Sensor battery reporting issues

General Discussion

Joe_Battaglia (Joe) October 9, 2017, 12:31pm 15

Yes I notified support about this and they confirmed it is an issue. Their suggestions was to change the battery 2-3 times a year.

Topic		Replies	Views
SmartThings Multipurpose Sensor Battery Devices & Integrations	72	24674	November 24, 2017
Batteries please fix (ST devices die at around 67%) Connected Things	51	4552	July 13, 2017
Open/Close Sensors and Battery Devices & Integrations	37	2358	March 22, 2021
Multisensors Samsung Battery drop quickly after hub v3 firmware update Devices & Integrations	119	5041	March 25, 2021
Issues With Zigbee Sensor(s) Battery State Reporting? Connected Things	23	4379	April 20, 2021

ST Multi-Sensor battery reporting issues

Related topics