[ST Edge] vEdge Creator: a virtual device generator for end users

[h0ckeysk8er (Bruce Pinsky)]

@TAustin

In addition to @h0ckeysk8er’s suggestion, there is a counter/duration driver I have that might be of use to you. You could use it to build automations that trigger after x number of seconds/minutes/hours.

This driver (Edge Counter Utility V1), is available on my shared projects channel here , and discussion can be found in this topic . And here is an example of its use.

I also use the Edge Counter Utility to generate a looping effect to check if doors or gates are still open at a recurring set interval (e.g. every 15 mins). By resetting the duration to zero every time the routine to check the open/close sensor status for a device runs, it will keep checking the sensor status indefinitely until the Counter Utility device is turned off.