SmartThings Edge Driver (aqara-fp300-zigbee) The most(ly) complete Zigbee integration for the Aqara FP300 (lumi.sensor_occupy.agl8 / PS-S04D) on SmartThings. This community Edge Driver unlocks the full feature set of the FP300’s dual mmWave + PIR sensor, environmental sensors (temperature, humidit…

Thank you again for your help. I tried deleting and adding the device several times, but didn’t reset it in-between. Having said that, I removed the batteries, and the seller changed between Zigbee and Thread, so that probably reset it. I haven’t checked how it works with your new driver. If I und…

[image] rob_uk: I will follow your advice of removing, resetting, and adding it again. When you delete the device in the SmartThings app, it should automatically go into pairing mode, but sometimes not. You should wait about one minute, before you press and hold the button until the LED start…

I haven’t removed and added the FP300 yet, but it must be using your new driver now because it’s showing the battery level now. It still incorrectly detects motion every couple of hours. I’ve changed the motion sensitivity (presence detection sensitivity) to low and disabled detection over 3 metres,…

[image] rob_uk: I might keep one FP300 for the bathroom Same here. Works well enough now with the default settings of my driver. I’ll keep the device in Zigbee mode, because in Thread mode it randomly went offline. Hopefully, they’ll fix it in the next firmware update. I have added a huge se…

Thanks for your help, your driver, and all the information in your updated post. Sorry for my tardiness in replying.

[image] Andreas_Roedl: Only works sometimes in the Aqara Home app Might that be the reason why the device is still giving me temperature and light readings even though I’ve set those to off in the settings?

[image] TOMillr: Might that be the reason why the device is still giving me temperature and light readings even though I’ve set those to off in the settings? Who knows? I’m not the developer of the device’s firmware.

After updating the Zigbee firmware to the latest build 0.0.0_6542, motion and presence detection is no longer working properly with my ST hub. However, when I pair the sensor to an Aqara hub, everything works as intended. Did they change something in the firmware that makes the ST device driver not …

[image] TOMillr: After updating the Zigbee firmware to the latest build 0.0.0_6542, motion and presence detection is no longer working properly with my ST hub. I can test it later today tomorrow.

[ST Edge] Aqara FP300 (Zigbee)

Devices & Integrations Community Created Drivers

Andreas_Roedl April 20, 2026, 9:24pm 60

PSA: To change some of the settings you have to press the physical button on the device first. Only works sometimes in the Aqara Home app …

Topic		Replies	Views
New Aqara FP300 battery powered human presence sensor (Matter, Thread) 2 yr battery Devices & Integrations	70	5582	May 31, 2026
Aqara FP2 Tested with SmartThings? Devices & Integrations	318	15280	July 18, 2025
Edge Driver for Aqara Smoke Sensor JY-GZ-01AQ? Devices & Integrations	41	2078	November 16, 2023
Driver for Aqara FP1E Presence Sensor (Direct Hub Connection via Zigbee) Devices & Integrations zigbee , developers , edge-device	27	1970	May 27, 2025
Edge Driver for Aqara Temperature and Humidity Sensor? Devices & Integrations	103	12952	December 6, 2024

[ST Edge] Aqara FP300 (Zigbee)

Related topics