Zooz Outdoor Motion Sensor 1.1
I just posted a new version that has a tile that shows the firmware version, but after upgrading the handler that tile will be empty until the next time the device wakes up. You can force the device to wake up by removing the batteries for about 5 seconds and then putting them back in.
The new version also has the following settings, but they’re only supported by firmware 1.4 and above.
Motion Cleared Delay: The delay between the last motion event and the device reporting motion inactive.
Brightness Trigger: The lux value below which basic_set command is reported to the hub.
(I believe this only affects devices that have been manually added to this device’s association group)