Mi motion sensor (RTCGQ01LM) - connect to smarthings

[TapioX]

Maybe these instructions can help you

@OpethNJ

Having set everything up with the above this is the approach I take every time and every time it works to get these devices registered.

1. I make sure that I can get the Sensor within 1 inch of the front of my Aeotec v3 hub.
2. Run a scan for devices in Smartthings
3. For each sensor I follow the process of holding down the pairing button for 5 seconds until I see the 3 blinks. I then press the reset button on a 1 second cadence always ending it before the scanning cycle completes. (No proof currently but again my perception of this is over a few different deployments is that ending before the scan cycle works the best)

• For the plug its generally the same except you are holding down the Power Button