Anyone else having issues with the latest Aeotec MultiSensor 6 edge driver from Aeotec Group? My device stopped working around 10 AM this morning and is stuck with all the readings at that time. I’ve tried powering off and on and rebooting hub with no luck. Assume this is the right place to log…please fix!
Driver Version: 2024-09-17T14:30:16.75128079
I can confirm several users of my community reported their Multisensor 6 stopped reporting motion around 12h ago.
I have 7 of them, they all stopped reporting motion around the same time.
Me too. I rely on the illuminance reading and it’s stuck at zero lux. Same driver update on 17 Sept as reported in original post.
Will I be able to roll back the driver to the previous version?
Also same issue here. Both Aeotec sensors stopped working at c1am GMT
UPDATE…
A new driver has been applied (by Aeotec after I contacted their support team) and all is now working again
2024-09-18T07:39:21.998698387
Pleased to see that the issue was addressed quickly
My device is powered by USB. Thanks
Has the issue resolved itself? My multisensor 6 received a new driver a few hours ago and all now working ok. I rebooted my hub which might have accelerated the uploading of the new driver …
I confirmed I received the updated 9/18 driver this morning. After rebooting my hub the multi sensor is now working as expected! Thanks for the follow up.