Seeing some questions about this. If you were using the old Groovy smartapp for integration with Konnected.io , here’s their official support page for how to migrate to the new platform.
Not sure if @heythisisnate has any more to add.
Seeing some questions about this. If you were using the old Groovy smartapp for integration with Konnected.io , here’s their official support page for how to migrate to the new platform.
Not sure if @heythisisnate has any more to add.
Hopefully Konnected will release a local Edge driver soon, but until then you can also use Tasmota which is 100% local and works great. Their firmware supports basic rules on the ESP8266 and the Edge driver has http (post/get) for other devices which is great for integration and reducing the routines required to do basic tasks.
I installed all of the drivers but was unable to get the konnected board to show up on my computer when plugged in. I have used multiple micro USB cables. Any thoughts?
This wouldn’t have anything to do with Groovy, Edge or ST at all for that matter. You might try the Konnected forum directly.
good idea. I was hoping for edge drivers etc. for this device. I’m hoping I’ll get answered over there! Thank you