Hub Firmware Beta 0.26.12

[Automated_House (Jimmy)]

i’m guessing that solves this:

SmartThings IDE Shows Z-Wave: Not Functional

I bought a new SmartThings hub and have not been able to connect a single Z-Wave device. Not a single one. I have GoControl Light Switches that wont connect and GE light switches that wont connect. New devices out of the box. I have no Z-Wave network yet because I haven’t been able to connect anything. I have extensively Googled the issue and found the IDE site. There it shows that my Z-wave state as Not Functional. I have gone into utilities and enabled Z-Wave module. I have tried to repair the network. I have tried to exclude the devices. I have reset the hub to factory more times than I can remember. I have emailed support. I have not called them yet due to horror stories of everyone else calling the. I’m about to return the stupid thing. I should mention that I have no issues with Zigb…