How to associate 2 devices (Fibaro parameter discussion starts post #20)

[Paralytic]

I got this working recently - details here:

Wireless Switch for New Light in UK - Best Solution?

Hi, another update. I thought I’d try the bypass module alone and, despite what the manuals say, calibration without any other load was successful and I can now control the remote lights via the second Dimmer 2. I now have this set up in two places. I’ve a single wall switch in our bedroom with a Dimmer 2 and Bypass controlling the ceiling light, also with a Dimmer 2 and Bypass on that light circuit. And I’ve a double wall switch in our open plan living area, with a Dimmer 2 and Bypass, each switch controlling one of two ceiling lights, each with their own Dimmer 2 and Bypass on their circuit. So, in total - 5 Dimmer 2s and 5 Bypass to control the 3 lights - approaching £300. Not cheap, but cheaper than having to run new wiring and then replastering but with the added benefit that I ca…

I’ve only done a one way association for now - from a Dimmer 2 behind a light switch connected to a 2 gang switch (toggle for now, but searching for the right momentary) and each switch controls one association group.

Here’s what’s in my Dimmer 2 DTH settings (@zcapr17’s DTH)

This works so that when either physical switch is toggled, the associated device gets the corresponding command.

@daniionescubrasov do you have Dimmer 2’s physically wired up? I noticed that when i changed the Dimmer 2 on/off state via the ST app, the command did not look like it was send to the associated devices.