GE 45600 Handheld Remote as SmartThings Scene Controller (Edited: Does not work!)

[jimmay3]

GE 45600 Remote is now functional again on V2 Hub… @Duncan, Thanks…

Having trouble adding lights to GE 45600 after migration to v2

@Duncan, yes you fixed it!!! The GE45600 Remote works on V2 Hub with Latest Firmware update 0.14.32… I tested it with regular zwave wall switches, plugin modules and dimmer switches… NO SPECIAL DEVICE HANDLERS NEEDED, ST finds it and works perfect (easy install)!!! Just remember, it can only control other zwave devices… I used the below to configure it: 45600 REMOTE - BASIC SMARTTHINGS SETUP -Factory Reset/Clear the GE45600 Remote: -Ensure Remote is not already on a Z-Wave Network (Reset/Clear) and to clear all devices from it (if already installed in ST, then use Removal procedure below, prior to Resetting/Clearing remote): -Hold Setup till Red/Green flash twice. -Type 969, complete when green flashes twice. -Note that none of the remote on/off buttons flash now (all devices c…