See this guide: https://support.smartthings.com/hc/en-us/articles/201023520-How-can-I-open-and-close-my-garage-door-with-SmartThings- Questions about the guide: Instead of a multi sensor could I use; A) SmartThings Open/Closed Sensor B) EcoLink Tilt Sensor Thanks!

Both should work. I used a multi sensor rathar than match up the open/closed with a Mimolite to do the open/close

I use the ecolink tilt sensor and it works.

Do any of you know the status of this article? [image] Does the MIMOlite device add child devices like with Vera? Connected Things I just bought one of these along with an open/close wired door sensor. Fortrezz’s documentation about setting this up as a garage door opene…

@gjanes , Take a look at this thread below. My mimolite has been working great being hardwired into the switch and open/close sensor. [image] Mimolite for garage door and magnetic door contact Devices & Integrations @mb323 , sure Mark no problem. I’m mobile right now, b…

That sounds exactly like what I’m looking for. I’m still very new to ST (actually doing preliminary research prior to purchasing a hub to replace my Revolv), so as a follow-up, can you explain what the code is used for? I’m comfortable with writing and editing code, just wondering how it all works…

@gjanes , no problem, and welcome to ST. Glad to here you’re good with coding, while not a requirement for ST, it will will help you extend ST beyond the “out of the box” apps and device types and customize it to to your heart’s desire. First, once you get your hub you’ll want to get acquainted wit…

I’ve got it hooked up and the control (switching) seems to be working fairly well. However, the open/closed status is not updating. I’ve got my magnetic sensor set to NC, and when I open the door the little green light on the mimolite goes off. Then when I close the garage door, the green light t…

@johnconstantelo , I determined the issue appears to have been poor z-wave signal strength due to some sort of interference due to the insulation or something else in the wall, plus the cold temperature in the garage. Re-wired to get the mimolite inside the house and it appears to be working. I hav…

Hi @gjanes , I’m set up as normally closed as well for the same reason. The Power logic is there to let you know if the mimolite has power. It doesn’t need to be wired up any differently than you have it now, and the jumper still stays removed for momentary capabilities. The mimolite will send an …

Garage Door Sensor?

Devices & Integrations

johnconstantelo January 19, 2015, 3:18pm 5

@gjanes, Take a look at this thread below. My mimolite has been working great being hardwired into the switch and open/close sensor.

Topic		Replies	Views
Does the MIMOlite device add child devices like with Vera? Connected Things	2	1358	January 18, 2015
Garage Door Automation with Mimolite Devices & Integrations	8	2308	October 6, 2020
Mimolite and tilt sensor for garage door opener Devices & Integrations	2	1905	May 24, 2016
Opening your garage... ideas to pursue Connected Things	84	6128	April 19, 2014
Mimolite for garage door and magnetic door contact Devices & Integrations	147	30262	March 30, 2019

Garage Door Sensor?

Related topics