Curtain hardware information?

[vint83]

After some extensive research I ended up ordering custom rod from Ali Express:
http://www.aliexpress.com/item/motorized-curtain-track-smart-home-used-motorized-curtain-DOOYA-motor-DT52S-free-shipping/32217406062.html

eRod was too short for my window and other options were just way to expensive or very old tech.

Plus you will need something like:

Aeon micro motor controller DSC14104

Since you have more than one SmartApp that you want to control the shades, this little app below allows you to use two Momentary Button Tiles (which you can create in the IDE), one for Up and one for Down. Then you can use these virtual switches in the apps that you want to control the motor controller. All of this assumes that you don’t need to use the Stop command. I haven’t tested this, but it should work. Check it out and let me know. Note: in each case you want to turn On the virtual switch to cause the motor to run Up or Down. /** * Virtual Shade Mapper * * Copyright 2015 Bruce Ravenel * * Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except * in compliance with the License. You may obtain a copy of the License at: * * …

or (if you don’t need z-wave)
DC42
e.g. http://www.aliexpress.com/item/all-kinds-of-remote-controller-for-choice/32528188261.html