Association between qubino switch and fibaro plug

[Gagag87]

As far as i see, None of these devices have official edge drivers. I also couldn’t find any other edge driver either

If these are not available, is it possible to use CLI to set associations between them?

[Automated_House (Jimmy)]

You can use this driver to set associations for any zwave device

(EDGE Driver-Mc): Z-Wave Device Config Mc

Hi @GiacomoF I managed to control switch 2 with association groups. You have to put Endpoint 2 instead of endpoint 1 [Screenshot_20220915-152607] Although the endpoint reading of the device says that it has endpoint 0 and 1, for the association endpoint 0 and 1 correspond to switch 1 and endpoint 2 to switch 2 [Screenshot_20220915-153259] I don’t know if it will be the same for other manufacturers.

[Gagag87]

This is great but for this specific device, i can not change the driver. It doesnt give me the option. All other devices let me choose

How do i make it show?

[HalD (Hal)]

@Gagag87

for this specific device, i can not change the driver

Is it on an edge driver now?

[Gagag87]

I added edge driver and re registered device. All working fine now. Thank you