I wrote a routine that states wait 1 minute after the last detection of motion on the P2 sensor and then turn off the light. I find that when the device is installed on the ST hub it operates with a cool down period of 55 to 60 seconds. As such, the turn off delay causes the light to stay on about 2…

Aqara P2 Matter over Thread - Cool Down Period Settings

Stephan4711 (Stephan ) October 9, 2025, 9:33am 10

maybe there can be a fix like: Zigbee Cooldown Time soldering solution the layout looks diffrent, I’m not sure which one to solder to achive the same result.

Topic		Replies	Views
Modify motion rest General Discussion archive_developers	8	891	September 12, 2013
SmartThings Motion Sensors Connected Things motionsensor	14	3778	March 14, 2016
Motion Sensor to turn off light/plug/switch? SmartApps & Automations	16	7231	July 17, 2015
New SmartSense motion sensors and sensitivity Devices & Integrations	17	11657	January 25, 2018
Ability to disable motion sensing for certain modes? Automation Ideas	31	8158	March 4, 2016

Aqara P2 Matter over Thread - Cool Down Period Settings

Related topics