Thanks for the post. This seems like what I’m hoping to do with the NXP module I’ve been playing with. I’m hoping to make a PCB based on what DIO’s or ADC’s I want to use, Relays, buttons, other sensors like temp/accel/piezo.
Quick question, have you figured out a good way to figure out what your Zigbee fingerprint looks like? I’ve been playing around with the NXP zigbee HA stack (free by the way!) and examples and I thought I knew what in and out clusters were being used but can never seem to get it to be auto recognized when I pair it. See my questions here.
Note that I was able to find these NXP modules for about $10 so even with a PCB and battery I was hoping to beat the $25 cost of the monoprice.com door sensor here.
The NXP module is the JN5168-001-M00.
I also started a thread here.