WD and WT00Z help

[JDRoberts]

@Toadie

Ok, I got this all wired up and working, plugged into smart things, but I have one challenge…

Switch 1 - Bottom of stairs - lights go on and off physically, ST implementation works
Switch 2 - Top of stairs - nothing seems to work…

So you’re thinking… you didn’t pair them with your mini mote… but I did. Hit add, pressed the switch got the solid blue light, ran up stairs, repeated the process, solid blue light, good to go. Both switches appear in ST.

Not sure why they don’t appear to be connected?

Because an Add isn’t the same as an Associate. One adds the device to the network, the other links it to an individual device.

Read the following thread for the exact instructions in post 5 and follow them, well, exactly.

FAQ: Solution for Linear/GoControl 3-way switches? (WD500Z-1 and WT00Z-1) (Association options)

had great success with Linear’s WD500Z-1 Wall-Mount Dimmer’s, so I needed to convert a two way switch installation in the kitchen. Took a WD500Z and bought a WT00Z-1 Accessory Switch to go with it for the two-way install. Got them in, and now ST support is saying that the association, that is the only way to “pair” them can’t be done in the ST hub. Anyone else run into this before? Is there a solution other than ripping it all out?

( also note that when you do the association you will be working only with the minimote and your two switches. You will not use the SmartThings mobile app for this process.

So once you have added all 3 of these devices to the network and they all show up in the things list in SmartThings mobile app, then close the mobile app and just follow the specific instructions for creating an association using the minimote.)