Vivitek Projector Serial Commands over IP through Raspberry Pi - Help Needed

tgauchat · June 27, 2016, 8:38pm

My SmartThings + Arduino sketch does 433mhz transmission to raise and lower the screen, 12v trigger signal detect to activate the screen if ST is down, and on/off/mode via RS232 for the projector!

Here’s the DTH:

github.com

CosmicPuppy/SmartThings-ButtonsAsPIN/blob/master/devicetypes/cosmicpuppy/projector-screen-shield.src/projector-screen-shield.groovy

metadata {
	definition (name: "Projector Screen Shield", namespace: "CosmicPuppy", author: "Terry Gauchat") {
		capability "Actuator"
		capability "Switch"
		capability "Sensor"
        
        command "enable"
        command "disable"
        attribute "override", "enum", ["stopping", "stopped", "enabled", "disabled"]
        
        command "screenOn"
        command "screenOff"
        attribute "screen", "enum", ["on", "off"]
        
        command "projecOn"
        command "projecOff"
        attribute "projectorSignal", "enum", ["on", "off"]
	}

	// Simulator metadata

This file has been truncated. show original

And the Arduino Sketch…

*Dang… Not in the same Repo. Post it later.

Topic		Replies	Views
RS-232 Serial device control from SmartThings and MQTT: One man's journey past The Cliffs of Insanity and into calmer waters Projects & Stories requires_server , project_av	8	4549	July 15, 2018
Telnet Connected Things	36	14365	June 18, 2015
PJLink Commands via Smartthings / Webcore Devices & Integrations	0	462	November 26, 2019
Projector Screen - Which ones will work? Devices & Integrations	3	2357	May 15, 2017
How to connection to a Raspberry Pi Devices & Integrations	6	7055	October 15, 2017

Vivitek Projector Serial Commands over IP through Raspberry Pi - Help Needed

Related topics