Vision Z-Wave In Wall

[Velile]

Rene Campos wrote a review of the Enerwave dual switch. It probably applies to the Vision.
"Adding this device to a SmartThings controller was not simple. Following the instructions supplied by Enerwave will only get you one switch working. After a couple of hours searching on the internet I found a thread about this module and the SmartThings controller. Followed the directions on the thread and got my 2 switches working fine. Just that the 2nd relay status takes up to 2 or 3 minutes to update the status, not a big deal.

The thread with the instructions is in the following site:

ZWN-RSM2 Create a new device type

@tail24 Sorry for the delay. I used the virtual device type code and created a device type using it for each tile I wanted for each control device. For me 1 virtual device for dining room light 1 virtual device for dining room fan 1 virtual device for living room light (actually is 2 lights) 1 virtual device for living room fan (actually is 2 fan) Then I used the aeon power strip binder app modified it from 4 relays and to select multiple devices to two, I also had to change compatibility to “switch” from “Switch” then installed it for each for each virtual switch tile above selecting which relays it would control. I found all the code in the forums and in the examples in “My Device Types” and “My Smart Apps” Let me know if you need more info.