Virtual Device Sync

Hi all, All of my 2 and 3 gang switches that were binded using Virtual Device Sync and worked flawlessly for over a year have just stopped working. It would appear my only option is to remove all of them (along with the virtual switches) and re-install. Before I start this does anyone have any ideas to how i could get it back to where it was? Cheers

This may be something you already tried, but log into the IDE and try rebooting your hub before doing anything drastic. It just might get it back in sync.

Thanks, yeah I have done a reboot but that didn’t seem to work. However, some of them appear to be working again now (6 or so hours later) so I will just wait and see if the rest come back. Cheers

1 Like