Using Securify Contact & Motion sensors with SmartThings

[JDRoberts]

These need a custom device type. Fortunately one of the community members has created one and shared it.

Begin by reading the following FAQ on using custom types:

[OBSOLETE] FAQ: An Overview of Using Custom Code in SmartThings (SmartThings Classic, Groovy Code)

The original FAQ information in this thread refers to the original smartthings architecture, which was in place through the end of 2022 and a little beyond. Custom code was written in the groovy programming language and ran in the smartthings cloud. As of May 2023, you can no longer add new Groovy DTH‘s or smartapps to your smartthings account. So if you came here because of a link in an old forum thread, or on another site, I’m afraid the Groovy information is no longer usable. All of this was replaced by a new architecture. Cloud to cloud integrations use the smartthings API. Hub connected devices, mostly Zigbee and zwave, now use “Edge Drivers,” written in the LUA programming language. Here’s the official announcement on those: The process for using a custom Edge Driver in the new …

Then go to the device type thread for this model to get the actual code:

[OBSOLETE] Securifi SZ-PIR02 motion sensor

Hi, So I have the Securifi SZ-PIR02 motion sensor working with ST now. Will post a link to the code shortly. metadata { definition (name: "Securifi SZ-PIR02", namespace: "sozonoff", author: "Sozonoff") { capability "Motion Sensor" capability "Sensor" capability "Configuration" capability "Refresh" command "enrollResponse" fingerprint inClusters: "0000,0003,0500", outClusters: "0003" } // simulator metadata simulator { status "active": "zone report :: type: 19 value: 0031" status "inactive": "zone report :: type: 19 value: 0030" } // UI tile definitions tiles { standardTile("motion", "device.motion", width: 2, height: 2) { state("active", label:'motion', icon:"st.motion.motion.active", backgroundColor:"#53a7c0") state("i…