Swap 3-Way Master & Slave

Devices & Integrations
1

Hello

I have a Jasco 3-way Z-Wave switches that were installed by my contractor when I was having some work done on my house. I want to swap the location of the master and slave switch so I can create double-tap actions, that only seem to work from the master. My switch wires look like this:

Master:
White: Neutral
Red: Load
Black: Line
Grey: Traveler

Slave:
White: Neutral
Red: Tied to Black
Black: Tied to Red
Grey: Traveler

To swap, can I just swap the switches, and in the new master location put the red in Load and black in line, while tying those two together at the new slave location?

Thanks.
GBooks

2

You need to figure out which wire is the load and line at the slave location. But honestly just trying that configuration won’t hurt anything. You will know immediately if you need to switch the red and black wires.

3

Just trying that configuration did not hurt anything, but it also didn’t work. The switches just did nothing, and the little blue light did not come on. It sounds like I will need help from someone that understands electricity better than I do!

Thanks.
GBooks