Schlage Camelot control lights

[garyd9 (Gary D)]

Okay… I’ve updated my Schlage Touchscreen Lock device type code to pass through the source of a lock/unlock event. This is in preparation for doing the requested smartApp… I needed the device type to pass to the smartApps the method used for locking the door. Tomorrow I’ll whip out some code for toggling a switch when a door is LOCKED (with a filter on how it was locked.)

You should be able to use that with a virtual switch to change modes or HH events.

If you aren’t already using it, here’s the device type code:

(Enhanced) Z-Wave Schlage Touchscreen Lock

UPDATED August 22nd, 2015 (see below) As promised elsewhere, here’s my device type for the Schlage touchscreen door lock/deadbolt. This enables querying and setting the door alarm (off/alert/tamper/kick), door alarm sensitivity, and auto-lock modes. (There’s also support for lock/leave and vacation mode, but I don’t have them on the config panel yet.) One thing about this lock is that it’s a SLOW device in z-wave terms. The turnaround time for sending a command and getting a response can be several seconds. So, if you are using this, you’ll notice that trying to change, for example, the alarm mode, will result in the tile going blank with the word “loading…” in it… and then it populating a few seconds later. When changing the alarm MODE, the alarm sensitivity must be re-queried (a…