FYI: the new Monitor went wonky last night after I installed and this am showed 300gal used and was in alarm state (installed correctly on new clean pipe, etc) so re-calibrated and it seemed OK today. Called to get procedure to reset totals because they don’t provide that function in App (they are considering it) and they can’t reset on their end. You have to remove the location (not the device) from your account and start from scratch re-installing the Monitor. Finally got it back up and running (it’s tempermental about WiFi when setting up). However, the DH quit talking to it even though the SL Location and API key was the same. Couldn’t even remove the SM without first force removing the DH then SM. Reinstalled SM which brought back the DH and everything started working again. So beware if you have to remove the location from your account and set up again to reset totals - it may crash the SmartApp and require a complete re-install. Don’t forget to re-assign the SL device in any automations…