I actually excluded, reset and included the dimmer with your DTH being the only one installed. As mentioned prior, if I swap the DTH with the generic ST one, it works properly (ST app shows proper off status so the piston is able to turn it back on when needed).
As for the led notification piston, it loops all my notification devices and for each device it loops for each led, however my intention was for it to only send commands to the devices when the updated table shows that a value has changed. Did I do this incorrectly and I am sending a zwave command for each led on each device?
@JDRoberts I think you have these super powers… Would it be possible for you to move the last few posts to the WD200 related thread? I mistakenly posted in the WS200 thread and am now derailing the thread.