The full technical documentation for this device is here…
I found a different Parent/Child DTH that works better for me, it’s less chatty, automatic power reporting doesn’t work like the other DTH, but refresh works, and it doesn’t send messages continuously to the hub.
I just edited the DTH to add the “fingerprint” of the Greenwave to be accepted at inclusion.
I did ask the author of the above DTH to see if he could adapt it, but he only works with companies directly for integrations, and said not having the physical device would be x5 more work.
To get rid of the flashing spinning wheel, I used Z-Wave Tweaker to change paramter 4 to 0
Short version:
- param 0: Power change required to send a notification, in % from 1 to 100, default 10
- param 1: Keep alive time, in minutes from 1 to 255, default 2
- param 2: Colour wheel selection, read only
- param 3: State after power loss, 0 = all off, 1 = remember last state, 2 = all on, default 2
- param 4: Led for network error, 0 = disable, 1 = enable, default 0
- assoc group 1: Colour wheel change
- assoc group 2: Relay health
- assoc group 3: Power value change
- assoc group 4: Over-current protection