[OBSOLETE] Four button Tuya Zigbee device DTH (DTH link in post #7) (Same device from multiple brands: Zemismart, Yagusmart, Losonho , DYHF, etc)

[erickv (Erick)]

Hi, @Trakker2

A few weeks ago I was able to translate the Zigbee configuration commands into ST Edge Lua and it works properly in a MOES TS004F, but I was wondering… is it possible that these steps are applicable for rebranded TS004F or even the 3-Button model (TS0043 model if I’m correct)?

For reference, I mean these steps you shared with us:

@Trakker2

cmd += zigbee.readAttribute(0x0000, [0x0004, 0x000, 0x0001, 0x0005, 0x0007, 0xfffe], [:], delay=200)    // Cluster: Basic, attributes: Man.name, ZLC ver, App ver, Model Id, Power Source, Unknown 0xfffe
cmd += zigbee.readAttribute(0x0006, 0x8004, [:], delay=50)                      // success / 0x00
cmd += zigbee.readAttribute(0xE001, 0xD011, [:], delay=50)                      // Unsupported attribute (0x86)
cmd += zigbee.readAttribute(0x0001, [0x0020, 0x0021], [:], delay=50)            // Battery voltage + Battery Percentage Remaining
cmd += zigbee.writeAttribute(0x0006, 0x8004, 0x30, 0x01, [:], delay=50)         // switch into Scene Mode !
cmd += zigbee.readAttribute(0x0006, 0x8004, [:], delay=50)

And also, for everyone here, I’d really appreciate it if you could test the driver I developed for this device. A community member confirmed at this thread that it works ok with a not-even-branded TS004F, so I was hoping to get some feedback from you if possible

So, I’ll leave my channels below = )

• Main channel: @erickv Shared Drivers
• Dev channel: dev-@erickv Shared Drivers