I got one of these and installed it, and started running into issues. The switch showed up in smartthings immediately, and will turn on and off power to the ceiling fan when you physically operate the switch, but smartthings has no actual control over the device. It shows on at all times, regardless…

[image] MrYenko: Ideas? Hi, and welcome to the Community. There are several discussions on this device, so I highly recommend doing a search to find and use a DH specifically designed for this. ST’s default DH is a dimmer, not a fan switch. Here’s the result of a quick search: https://com…

[image] MrYenko: There is also no speed control on the switch I have seen this before. I have had that symptom several times. Each time it was because the values that decide the different speed zones were not written in the IDE on the Web under the device. I have fixed it 2 different ways. …

It’s about time ST really put out official support for this switch. You have good advice above but really, Smartthings need to get on this. Furthermore, the LED option on this for ‘always off’ does not work. How hard can it be?

If I remember right you have to change the DTH to smart fan not switch which it defaults too.

[image] Nezmo: the LED option on this for ‘always off’ does not work. How hard can it be? Is that smartthings fault or the switch manufacturer? There is a smart app that you can install to force toggle this to compensate for the switches inability to do this.

[image] TN_Oldman: Is that smartthings fault or the switch manufacturer? I put it down to us having to use the dimmer switch device handler and that an official one has not been released. I assumed the code for the LED in these is different to the dimmer but I could be wrong. [image] TN_…

Ok, been reading a lot of posts and cannot find one dealing with this issue. In the kitchen/dinette combo room I have a triple gang box with one switch handling the kitchen can lights, one switch handling the lights on the fan and one switch handling the on/off of the fan blades. There are two sep…

I just replied to your other post. [image] GE Fan Controller not working Devices & Integrations You should install it the same as the other switches. If the device won’t pair and the LED is not on, this would indicate the switch does not have power. Check that the line …

Thanks. I posted here to get maximum coverage since this was a similar ongoing thread. And I do understand the ‘dimmer’ nature of the fan controller. Just aggravating that two different fan controllers were not working.

i used the custom dth here and got it in my app, i can see the settings and turn the fan on and off, but regardless of what speed button i select it stays the same speed (approximately medium) i know the switch is on high, and prior to the dth i could adjust the speeds thru the slider and it would …

GE (Jasco) Z-Wave fan controller troubleshooting

Devices & Integrations

jhamstead February 6, 2017, 6:28pm 9

I just replied to your other post.

Topic		Replies	Views
GE Z-Wave Wireless Smart Fan Speed Control, 3-Speed, In-Wall Ideas and Suggestions	49	12018	November 21, 2017
Ceiling fan integration Connected Things	8	2488	June 23, 2015
GE Fan Controller not working Devices & Integrations	20	6236	February 7, 2017
Ceiling Fans & Switches Devices & Integrations	18	11179	February 12, 2017
GE 3 Speed Fan Control Devices & Integrations	12	3210	September 23, 2019

GE (Jasco) Z-Wave fan controller troubleshooting

Related topics