Edge driver to Associate Eaton Dimmer Switch RF9642 does not show up for my device

[h0ckeysk8er (Bruce Pinsky)]

@JDRoberts

@h0ckeysk8er

Also, you may be able to use Association Groups even with one device using an Edge driver and the other using a DTH. You would want to configure the device ID of the Accessory dimmer in Association Group 2 of the Master dimmer.

Zwave direct association is not bidirectional.

If the OP wants turning on the accessory switch to cause the master switch to turn on via Z wave direct association, it doesn’t make any difference if the accessory switch is in the association groups in the firmware of the master switch. That doesn’t cause the master to turn on when the accessory turns on.

The master Has to be added to the association group in the firmware of the accessory switch.

If the accessory switch cannot be added to an edge driver that exposes the association groups then there’s no way to do it with Zwave association right now, because the stock Groovy DTH doesn’t expose those settings and you can no longer add a custom Groovy DTH (like the Z wave Tweaker).

So I am afraid that in the current situation, the only solution for using zwave direct association is to get the accessory switch matched with an edge driver that exposes the association groups.

Yeah, I see what you’re saying. I think I mis-read which direction he wanted the sync to happen.