(EDGE Driver-Mc): Zigbee Drivers for Motion, Open/Close, Moisture, Smoke-Co Sensors and others Devices

[Mariano_Colmenarejo]

@Giuseppe_Buzzanca

But seems it nerver reset to the no motion state, basically it remains always triggered into the motion detected state.

Hi @Giuseppe_Buzzanca

This is a vibration sensor and it usually has problems with sensitivity and is continuously sending activation events.

Look in the details view and read attribute sensor sensitivity to see what sensitivity it shows, between 0 and 3 the lower the value the less sensitivity.
The default value is 2.

Try changing it to value 1 in preference settings to see if it improves.

leave it still and see if it goes to inactive after about 3 minutes

In this post could see how works the sensor sensitivity

(EDGE Driver-Mc): Zigbee Switch Mc, Zigbee Switch Power Mc, Zigbee Multi Switch and Child Mc

Added to two drivers version Please could you try with Zigbee Motion Sensor Test ? Has a preference with sensibility settings: default is 2, According to TUYA documentation, the higher the value, the higher the sensitivity. Normally it has a range between 0 and 3, although it could be higher depending on the device The value of the attribute is sent and read on pairing, which is when the device is awake. If it is changed in preferences it is sent, but since the device will be asleep, it is supposed to queue it up and run it when it wakes up to send any movement or battery messages. When the device responds with the sensitivity value it will appear in the custom capability It’s in testing, see if it works It has signal metrics information capability too ──────────────…