Edge Driver for Aeotec Nano Switch Z139

Getting ready to install an Aeotec Nano Switch Z139.

Hoping to find a good Edge Driver which gives control over the type of switch (Toggle Button; Standard Switch, etc.).

Didn’t find an Edge Driver for it in Aeotec’s Edge Drivers:

Found a Z-Wave Switch in SmartThings Beta Edge Drivers Channel.

Can someone make a recommendation as to a good Edge Driver to use on this device?

Simple solution:

Aeotec Support recommended that I create a Routine:

If Aeotec Switch On for 2 seconds Turn Off

I was so focused on new Edge Drivers, I hadn’t even thought about it in this way :slight_smile: