Are all Z-Wave switches compatible?

[PhilB]

Here is a post you may find helpful.

Eaton RF9540-NAW ASPIRE integration help

I have the 9540 Aspire and i want to control it from the SmartThing without buying or integrating anything else. Is that possible? If so, how. I have read a LOT of information on here about cooper and the aspire switches but not one thread had an actual idiot resistant methodology of integration. People mention minimote, but is that needed if i don’t have slaves? And even if I buy one, and i’m willing, how to i then integrate all of that into the smartthing. Then someone had a link to a “DH” (not even sure what a DH is) but no instructions on how to use it. Any help would be appreciated. thanks.

I know you said the switches had not been networked but it may be necessary to reset them before pairing to the SmartThings hub. See your manual for that process.

Keep in mind too that when pairing, information is not repeated thru any existing mesh network. The hub must be brought within a few feet of the switch being paired in order to speak directly to it for the pairing process.