Adding GE 45600 basic remote - only
CosmicPuppy,
Adding a GE 45600 basic remote by itself to the SmartThings hub works, too.
Do the following:
-
Remove your remote from the current z-wave network. See Resetting Your Network in the manual. Command - Setup and 969.
-
Add your devices to the SmartThings app.
-
Add your GE basic remote to SmartThings under add a device and press Setup and 967 on the remote (Adding Devices - Lights / Nodes to All Control).
-
The SmartThings app will try to identify an unknown device for quite sometime. I just aborted after about a minute and was able to see the remote identified as an unknown device under SmartThings.
-
Now add z-wave devices to your remote and you should be able to control these devices from both the app and remote control.
Good luck! Hope this helps…