jeancharles:
Just a general question however most of the z-wave devices I’ve installed come with the warning to ensure they’re placed in their “permanently installed location.”
Why is that? Is there some sort of one-time association made? Does this have to do with the mesh network somehow? If I chose to move a device, does unregistering and registering it not work?
Curiosity is getting the best of me here, figured some of you might know.
We were just discussing this in detail in another topic earlier this week. Read the following thread, all will be revealed. (This is a clickable link.)
My network has about 30 devices, 3 locks, 20 lights/dimmers by GE, 4 repeaters by Aeon and 3 motion sensors by aeon. Most of the devices are concentrated in the front part of the house. The hub is located in the mid rear of the house. It’s definitely out of range without the repeaters. When I migrated over to v2, i specifically added the repeaters first and then the rest of the devices. So for about 2-3 weeks things worked but occasionally (at once a day) some command would fail to route. Especially true when I try to run a large routine, like turn all lights on and turn all lights off. What I would end up with is some lights not acting.
So last night I decided to see if clearing up the routing table, hoping would resolve the delay and I did the following:
Unplugged power and to…
1 Like